Cork Wall Tiles Vs Ceramic Wall Tiles to decorate walls in interior designing and decoration

Cork Wall Tiles Vs Ceramic Wall Tiles

To emphasize texture, use oblique lighting, which throws the hollows into shadow and highlights the peaks. Below Cork tiles make a warm, decorative coloring for bathrooms and other rooms, and they do much to camouflage poor wall surfaces.

Cork wall tiles

Most people think of wall tiles as being of the glazed ceramic variety, but for a textured finish to a room there are other types, such as cork. Cork tiles, as well as a being a popular choice as a floor covering, also make a decorative surface in bathrooms, where they contribute to insulation and warmth; in offices and children’s rooms, where they can double as pin boards; and in other rooms where they are used simply as a decorative device. Cork tiles are most commonly 30 cm square and about 3 mm thick. The type suitable as a wall covering are usually untreated, whereas flooring-quality types are sealed.

Always use the adhesive recommended by the tile manufacturer. Contact adhesives are applied both to the wall and to the back of the tile, while cork adhesive is spread only on the wall. It is important that the wall should be clean and free of grease.

HINTS AND TIPS

Natural cork is difficult to clean, so consider treating the tiles with a clear for, if you wish, colored) polyurethane sealer in a room where frequent cleaning may be necessary. • When tiling into corners, cut the last tile by holding a tile over the last whole fixed one. Then take another tile and place it over the two, but reaching right into the corner.

Mark a line along the edge of the top tile onto the surface of the middle one and cut along it with a craft knife to give a perfect fit.

Battens for fixing fibrous tiles to a ceiling need to be screwed into each joist to support the combined weight of the tiles. Above Mirror tiles are perfect in a bathroom, but the supporting wall must be perfectly flat. Don’t worry if the surface is uneven as long as it is reasonably firm – cork tiles are very forgiving and do an excellent job of camouflaging rough surfaces, With the aid of a plumb line and spirit level, mark vertical and horizontal starting lines for the tiling work. Even though cork tiles abut closely and do not show obvious joins, it is still worth applying the same principles of good procedure as you would when fixing ceramic tiles, so that cut tiles at either end of a wall are in symmetry.

Mirror tiles Convenient for bathroom use, mirror tiles are usually supplied with self-adhesive pads or strips attached to their reverse side. If you intend to fix more than one, bear in mind that any unevenness of the supporting surface behind may well cause the faces of the tiles to produce some very distorted reflections. Unless walls are perfect, it may be preferable to fix a sheet of plywood backing to the wall first, and then stick the mirror tiles to it for a completely distortion-free finish.

Quarry tiles and mosaics

Although equally hard wearing as ceramic tiles, and requiring similar fixing techniques, quarry tiles are unglazed and have more of a casual, country appearance – a look that is emphasized by their predominantly earthy coloration. Quarry tiles contain a high proportion of quartz and are not particularly porous, which makes them a suitable choice for kitchens. There may be slight natural color variations in quarry tiles, even in those from the same batch – a fact you can exploit when planning a color scheme. Small quarry tiles in a variety of shapes are also available, and these are suitable for creating mosaic patterns. If left untreated quarry tiles have a Matt appearance.

Interior game offers complete interior designing and decoration tips and hints to do yourself interior designing and decoration in your halls and rooms and your friends and relatives homes and apartments.

Leave a Reply

Your email address will not be published. Required fields are marked *