Plastering the walls with adhesives in interior designing and decoration

 

Lincrusta in  interior designing and decoration

This type of covering is stuck in place using an extremely strong adhesive in  interior designing and decoration and it is, therefore, difficult to remove. Use hot water and a scraper to ease the sheet from the wall, taking care not to pull away the plaster. Soak and then remove any remaining adhesive.

Cork wall tiles in  interior designing and decoration

Use a flexible scraper with force to lift away the Interior tiles, then soak the exposed adhesive with water or use a hot air stripper to soften the remaining adhesive in  interior designing and decoration.

Take care not to damage the wall plaster. Expanded polystyrene tiles Use a flexible scraper to ease the tiles away from the wall or ceiling, and then use a hot air stripper to soften the exposed adhesive before removing it with a flexible scraper or sharp shave hook. Be careful to protect your eyes, hands, Stripping ceilings Vinyl/easy strip Many vinyl papers are easy to strip in  interior designing and decoration since the top layer pulls away intact, leaving the backing paper stuck to the wall.

Loosen a corner of the vinyl at the foot, then pull the strip away, holding the vinyl out from the wall in  interior designing and decoration as you pull. Domestic steam strippers are perfectly safe to use because its water reservoir contains only cold water – the steam is produced at the face plate of the stripper.

Press the steam stripper against the paper using one hand and hold a scraper in the other. As the steam penetrates the paper, it will start to lift away from the plaster. Use your scraper to encourage this process. Get as close to the surface you are stripping as possible. Holding the steam stripper at arm’s length soon becomes very tiring. Repairing walls and ceilings once you have stripped and cleaned the walls and ceiling, you need to examine them for any defects, such as cracks and gaps in the plaster. Most such problems in  interior designing and decoration should have become evident during the preparation stages; some others, however, may not initially be obvious.

The most common of these is “blown” plaster, which occurs when patches of plaster lift away from the underlying wall. When wrapped with your knuckle, blown plaster has a distinctive hollow sound. Ideally, you should hack out this defective plaster and patch with fresh material. Although re-plastering an entire room is a major job – one that requires considerable skill and professional expertise – it is relatively easy to undertake minor repairs yourself. Filling a small crack o Start by raking out any loose material from the crack, using the corner of your filling knife. Now fill the crack by drawing your loaded filling knife across it, at right angles to the crack. Using a small paint- brush, wet the crack with water.

This stops the plaster from drying out the filler too quickly, causing it to crack or fall out. Fill the crack slightly proud of the surrounding plaster in  interior designing and decoration. Leave it to set and, when it is hard, sand it back flush using a medium grade of glass paper.