Make up a length of piping the width of the finished blind, and cut enough fabric to make a frill at least 10 times that measurement. With right sides of fabric and lining together, and the top of the lining 2 cm lower than the top of the fabric, stitch down the side edges. Press seam allowances towards the lining. Stitch the piping to the lower edge of blind, leaving turning free. Make up and gather a frill to fit the lower edge of the blind, distributing fullness evenly. Pin the frill in place over the piping, then pin the lining over the frill and stitch through all layers of fabric.
Turn blind right side out. Press, Position the tapes down the back of the blind, spacing them about 60 cm (24 in) apart. Turn over 2 cm at the top of the blind, trimming excess fabric from corners and miter them. Position the heading tape, covering the top of the vertical tapes. Stitch all tapes in place. Run cords through the loops in the tape as for Roman blinds. You may want to hang the blind first (according track used) so that you estimate the amount of cord needed for cord running through the cleat which will need to be longer than the, cleat, for example. The cord together tied to the cleat, Curtain part way up so that it.
ED-BLINDS
Position the tapes down the back of the blind. Pacing them about 60 cm(24 in) apart. Turn over 2 cm at the top of the blind, trimming excess fabric from comers and mitring them. Position the heading tape, covering the top of the vertical tape. Pitch all tapes in place. Run cords through he loops in the tape as for Roman blind pa e 119). You may want to hang the blind first (according to the type of track used) so that you estimate correctly the amount of cord needed for each length.
The cord running through the row of loops furthest from the cleat which will hold the cords will need to be longer than the cord nearest the cleat, for example. The cords are all pulled together and tied to the cleat to hold the curtain part way up so that it hangs in swags.